IP-CS7
Det här är en kraftfull och flexibel styrbox för CYP///s IP-6000 och IP-7000 HDMI/VGA över IP produkter. Efter att IP-CS7 har kopplats in på nätverket kommer den automatiskt att söka efter kompatibla sändare och mottagare att konfigurera. När du sedan kopplar upp dig med en webbläsare mot styrboxen kommer du ha full möjlighet att mixa och matcha mellan samtliga tillgängliga mottagare och sändare.
En efterfrågat funktion som finns är dubbla nätverksuttag där man kan använda en port för dedikerad trafik för styrning.
Man kan genom trigger portarna på baksidan aktivera fördefinierade funktioner eller förinställningar genom en enkel knapptryckning.
Ytterligare möjligheter till styrning finns genom RS-232, Telnet eller Webbgränssnittet.
The IP-CS7 is a powerful and flexible installation solution for controlling the CYP range of IP-6000's and IP-7000's. It is capable of simultaneously managing multiple IP extenders across the same network. The unit only requires installation within your network to start the configuration process. The IP-CS7 will search and discover all Transmitters and Receivers on the network, enabling simple configuration of a uni-cast or multicast installation.
When using the IP-CS7 WebGui, it is possible to define and control all of the TX/RX's on the network. It also allows the user to create pre-determined switching groups or presets for added control. The on board set up 'Wizard' adds simplicity to the installation process, guiding the installer through the setup and control features of the unit.
Dual LAN connectivity on the device allows the system to run on a bespoke IP network whilst the additional LAN allows for connection to a secondary network for control and configuration. This is particular useful when access may be prohibited via the LAN network, the IP-CS7 provides a direct link to the IP video network.
Using the WebGui the user has access to a 'Monitor & Control' area for simple drag and drop control and switching of sources. In this mode the user can see a preview of the content being delivered from the source. The system setup area of the WebGui has protected access rights so to prevent any changes being made to the system by other users. An alternative control method of the device can be achieved by using the Trigger Input interface. This interface allows the user to activate pre-defined functions or presets at the touch of a button. Standard control of the device can be achieved using RS-232, Telnet and the WebGui.
Features:
- Enables simple configuration and management of multiple IP6000/7000 devices via WebGui
- Supports point to point (unicast) and many to many (multicast) signal routing
- Video group presets available
- WebGui setup wizard for simple system set up and control with admin rights
- WebGui status of all connected TX's & RX's including IP Addresses and swapping feature
- PoE & Mains Powered
- Simple drag and drop control of input sources with visual preview
- Trigger input allows for simple touch button control of presets
- Standard control via RS-232, Telnet and WebGui
- Add more TX/RX’s to an existing system with ease
Specification:
| Input: | 2x RJ45 [2x Individual Network IP] 1x Phoenix (3 pin) [1x RS-232] 1x 3.5mm Stereo mini-jack [1x Infra Red Receiver] 1x Phoenix (10 pin) [1x Trigger In (8)] 1x USB Type A [1x Service Port Propriety Data] |
| Output: | 1x HDMI [1x HDMI Uncompressed AV and Data] |
| POE PSU: | PoE |
| PSU: | 5V/2.6A |
| Dimensions: | 117mm [W] x 135mm [D] x 25mm [H] |
| Net. Weight: | 640g |
| Gross Weight: | 1066g |
